This is the Elvo set-up for the Arendonk track, which is very flat and high grip, but I adapted it to the long wheelbase brace which Elvo wasn't running back then.
Front:
Blue spring, 30wt, 3mm limiters
Shock: 2-O, Camber link: 2-B, 1 washer
Camber: -1.5°, -0.5° toe-in, caster 30°
Schumacher Stagger Rib Yellow
Wing on shock tower
Arms below level
Rear:
Red spring, 27,5wt, red piston, 5mm limiters
Shock: 2-I, Camber link: 2-B (second hole from the bottom on tower)
Camber: -2°, 3° toe-in, 1° anti-squat
Schumacher Mini Pin Yellow, outer row cut off
CVD's below level
Other:
Long wheelbase brace on long wheelbase setting
Rear hubs on medium setting
Wing on low and forward position
30gr near nose
100gr of lead under battery pack
ESC: 1-3-1-1
Motor: CS 7,5T on 24/78
During the day (when traction levels are slightly decreasing), I do the following things:
- Front green spring
- Rear shock position: 1-extra inner hole
- 0° anti-squat
What you could change for racing indoors:
- Anti-roll bar
- 23/81 gearing
Car was amazing, easy TQ and victory on club race.
|