Quote:
Originally Posted by V-Rossi
Take a bit of material off with a dremel or file, you don't have to remove that much as it is quite close.
And of course you will have to do this with the T-plate as well, as the hingepins are closer to each other on the XXX block.
|
So you take away material both from the arms and the t-plate? I took away some material on the t-plate in front of the pivotblock - it feels bad to take away much from a place were there's little to begin with
I'm nearly always faster with my CR than with my CR2, so I need to try it all
