Thread: Some CR2 mods
View Single Post
  #34  
Old 01-10-2010
flipside flipside is offline
Mad Member
 
Join Date: Jul 2007
Posts: 1,047
Default

I would advise to use some kind of brace behind the shocktower, even when using the alloy pivot block. It gives extra strength to the shocktower, makes sure it won't rip out the bottom screw.

With minispikes, you don't have to worry about the car width too much, it will be ok with wathever hubs you use. The main reason for using a thinner wheel spacer is as vrossi says to make sure the driveshafts go in the outdrives a bit more.

Try one of the setups posted here:
http://www.rc-offroad.be/setup.htm

Oople race or eden park setup was really really good on your UK style astro tracks!!

I would also use the normal CR hubs, then you have the option to change the camber link height easily. The hubs you have will make the care narrower quite a bit (2mm), will give you even more steering. I only used these hubs on a very smooth astro track where the complete setup is all about lots of steering. Might be good on carpet tracks too.
Reply With Quote