Yeah, I'v done this like 5 times ^^
I thought there had been more rebound, only 1-2mm, do you run on carpet or dirt?
Thanks for helping!
Quote:
Originally Posted by ben
- Pull shock shaft to bottom
- fill nearly to the top with oil
- pump the shaft up and down 2-3 times till the bubbles come to the top and pull the shaft down to the bottom again.
- Once bubbles have dissapeared top the shock up with oil just above the top of the shock body.
- Screw on bleeder shock cap
- Slowly push the shaft up to the top so any excess oil comes out of the hole in the shock cap.
- Insert screw
- Now check the rebound the shock has by pumping the shaft up and down a few times. Push the shaft to the top and let go then see how far the shaft comes out. I normally run about 1 or 2 mm of rebound. Other people differ.
- If the shaft comes out too far, take the bleeder screw out and slowly push the shaft up to the top again.
- Repeat on the shock and they should be the same.
Any questions or queries please ask!!
Ben |