Looking at the electrics. I run the cells round the other way. The power cap is the other side of the slipper shaft next to the cells. The speedo is pushed right up against the servo with the switch on top. The motor in rotated, with the receiver pushed right up against the motor to stop the steering arm rubbing against it. Velco is where the PT goes.
Setups ball stud middle hole all round on the bulkheads. 3mm spacer on the front, 2mm on the rear. Rear hub ball stud nearest the wheel, 4mm spacer. Front hub the rear hole with a 3mm spacer
Shocks 2nd hole out from the inside on all the towers, and the inside hole on the rear wishbone and middle on the front. 30wt losi rear yellow springs, 35 front blue springs.
|