View Single Post
  #6  
Old 15-09-2011
Sumilidon Sumilidon is offline
Member
 
Join Date: Aug 2011
Posts: 134
Default

I had the same issue, had to re-bind, and immediately after the thing went to full acceleration.

I fixed it by having the TX ready to bind, then switching the RX on - at this point I sent the bind command from the TX.

The ESC was plugged into the battery port.

Once bound, I switched the ESC off, unplugged the ESC from the battery port and put into the throttle, switched on and set the ESC.

Finally I attached the servo.

Since then, no problems - it just seems to be very VERY picky for the initial binding if not done in a specific way.
Reply With Quote