[martgifford]

I have recently got a 22 second hand from a fellow oopłe member-Thanks Samd

It's Lipo Saddle format in mid motor.

Now I have a micro spek and low profile servo or a full size rx and servo

I have a Novak GTB to fit which is so tight to fit

Do I use the small rx and servo and place the Esc at the front with long wires to the motor

Or

Do I put the Esc on the little rear carbon shelf above the Lipos. But then you have the large power cap that I need to find a place for (unless I buy a small power cap and replace) - any recommendations for the power cap


Please help as I want to sort it for EPR this weekend

Any suggestions. The instructions are pretty poor, actually non-existent in explaining electrics setup

Thanks