Think i've killed a motor and esc?
Running my SCT last night when car cuts out, with a SP citrix 10.5T brushless system
Found that the yellow wire had disconnected itself from the motor.
Soldered the wire back on (+ checked that I hadn't bridged across any solder tabs), managed 1/2 lap and it cut out again.
ESC was red hot so let it cool, tried to run it again and nothing.
Tried recalibrating the esc but nothing
Today I connected a different motor to the esc and nothing (esc got really hot though!)
Connected the 105 motor to a different esc, it ran for 5 secs, smoked and then stopped.
From this I can deduce that both the esc and motor are both dead, unless there is something else I could try?
|