I made the side pods from 5mm Carbon, the front section was double decked to carry the brace posts.
I just moved the standard rear shock tower to the back with the camber link sections cut off and made a new camber link plate to go where the old tower came from, with slightly lower holes.
The rear carbon brace had a 4mm rubber tubes between it and the new carbon side pods, a bit like the Team Durango rear flex brace.
Wing mounts are some aftermarket make i forget, for the 511.
I ground a few mm of the rear drive shaft to give a little more room for flex.
The main carbon chassis was 8 racing
