Quote:
Originally Posted by mark christopher
what if you turn the pulley round on the shaft, is it offset?
|
Quote:
Originally Posted by bigred5765
what mark said may be you have the pulley on back wards ares clears the metal buy 2-3 mm
|
Thanks so much for the replies guys. Really helpful.
Interesting point about which way round the pulleys go, but Im fairly confident they are both correct.
In the next step:
you can see that the central pulley has an obvious "squared" part to one side, this is definately correct on mine.
The first pulley (the one thats rubbing) I cant be jsut so sure about, and unfortuantely cant check cause Im in work now.
But Im 99% sure that its right too, as the face of the pulley and the end of the layshaft are completely flush and level for the little M3 washer & locking screw to go on (see Step 2B on first post above)
?
