Not yet I was too impatient and took them off.
I did get a 4.7mm ball cup reamer from HK and started to ream one out but that quality too broke
Anyway so I ended up cutting a couple of slots in a TD ball stud and that helped to ream it out. Idealy would be squeezing it with a cutting tool/pliers so it creates a little burr or something that sticks out a little .
However I do think that they (RPMs) need to be deeper and sit further over the TD studs otherwise it seems like they don't really close up after mounting them and they pop off.
Im still going to try a couple of things