Quote:
Originally Posted by Robbiejuk
I think it was this one 
Definatly a wet weather set-up, I reckon it would be good on a clay or dirt track. |
Yep it's that one. Except I used the kit pistons and didn't drill them.
However think they are the 3 hole ones anyway so that will be a bit more confusing
. Can't remember now as haven't touched the setup for months.
Was there weight under servo on that setup?? Thats what I run anyway.
Quote:
Originally Posted by Robbiejuk
I have dremelled the motor plate on my Akula AKX2 SCT prototype to allow the pivot block on that to be moved up and down. But you cannot adjust anitsquat (increase it anyways) on the Tc02C because of the design of the rear end.
|
I have not actually done the antisquat mod either on the X-Pro. However have done it on the Akula, after a top recommendation, and its improved it greatly so would be worth trying. All you need to do is allow for clearance when the pivot block is raised.