Are you running the RS Pro in dual or sensored mode?
I find sensored tends to run quite a bit hotter than dual. If you are in this mode then check the timing on your motor endbell (factory settings on Tekin are usually 10-12 degrees. I don't have any experience with Vampire motors) then set your Boost setting using the hotwire facility to give an overall setting of around 30 degrees (e.g. 12 on the motor + 18 Boost = 30 degrees) this should run quite cool. Test this out then increase Boost until you reach a comfortable heat after 5 min runs (I aim for three lights flashing on my ESC and 68C/155F on my motor)
__________________
Tony Mulligan
DESC410R, DEX410, DEX210, Cream Extreme (the dog's b******s)
www.srcc.co.uk
|