Thread: KK2
View Single Post
  #4  
Old 15-07-2013
Col's Avatar
Col Col is offline
Awesome Admin
 
Join Date: Mar 2006
Location: York
Posts: 4,571
Send a message via AIM to Col
Default

I asked your question (actually I copied and pasted it) and have got 2 reply's so far.

Quote:
Yea, this is a KK2 reset. The facts say that there was probably a lot of noise on the battery power that got through the BEC to the KK2. (unless you heard a noticeable drop in power between start of high power and KK2 reset, which could indicate a low voltage condition, I think not unless you are running 2S)

You are doing the right thing by trying another power source for the KK2. I would add that perhaps you are over amping your battery. Do you know what the voltage drops to under that load? Maybe carefully test on the ground with an volt meter hokked up.

The specs say it will work on either 5v or 6v. I use 5v. Try one and then the other if the one still resets?
Quote:
I had the same thing happen with 2200 20C batteries.
Nothing wrong with the FC, the battery could not dump enough power to the motors.
A full recharge was better but 40C batteries never do it.
Reply With Quote