Quote:
Originally Posted by thorny97
Thanks for that Danny,
The available settings on the flow are auto brake, brake ramp, brake type, initial drive, torque timing, boost timing, boost angle, and then cut off.
I have got initial drive set at 2% out of 5%
|
looking at that, I'd say, lower the torque timing right down. drop to minimum on initial drive and dont run any boost to start. Try setting an exponential curve on transmitter too. I run between 25-45% depending on the track. Curve should slope gradually upwards. It varies on transmitters as to whether its - or + expo to achieve it.
If your really set on a motor change, I think the reedy motors are known to put power down soft and smoothly.