Quote:
Originally Posted by fredswain
I don't like the idea of running wider front axles to push the 2.2 wheels outwards. I know this is similar to running the original sized offset wheels with narrow axles but the older cars had a greater scrub radius than modern cars. I want to keep the more favorable scrub radius. My solution was to 3D model a stock arm and then widen it so that the front end width is where it should be with modern wheels and stock offset axles. The benefit is that the front arms are now close in length to the rear arms. I had them 3D printed. They work great. This is the first version. I'm still going to change them a little bit. I'm also making new rear arms that look stock. They too are slightly wider but when used with B4 cvd's and hubs will give proper width in back with modern offset wheels as well. At that point all 4 arms will be the same length.
|
Great idea, I would buy some if you want to sell them.