Head angle I'm sure is 82 degree, if you don't have that cutting tool a 90 will do, but it won't support the head well and all the pressure will be in a small area at thinnest point. If the cf sheet is not very thick, the countersink taper will be knifed edged and it will be very easy to be a de-lamination point. Probably ,ADR this sound drastic, but if the screw is done up very tight it will damage the material with a 90 degree cut.
Like Daniel said, use some wood, but if you clamp the sheet down on wood that hasn't been drilled, when the drill tip breeches thought the material it is less likely to splinter. Constant high speed and not too much pressure will also help. From memory, carbon is best drilled with a dagger type drill but at work I use normal hss and they work no problem.
__________________
Yokomo BMax 2
|