Turbo timing
I know this is not a Hobbywing section but bear with me. The principles of the esc software seem on the face of it largely similar to the Hotwire in the sense of boost and turbo. My issue is that when I run the same settings on the Tekin in 4wd as i do on the HW in 2wd, that the same effect does not seem to happen. The motor in 4wd is Novak 6.5 and my Hotwire settings (V223) are sensored and zero boost with 20 degrees of turbo timing. Gear ratio of around 10:1 in Durango 410. Now it is quickish but seems to lack top end. It does not seem to have a 'step up' as you would expect with 20 degrees of turbo dialled in. The can timing is set to zero but i have tried it more advanced too. On the bench with no pinion I cannot detect any change in pitch at full throttle when the turbo timing should be kicking in (which you can doing the same with HW). Question is it most likely to be software, hardware or motor related? Sensor cable seems ok with the test with the 3 lights on the esc.
Any thoughts.
Cheers
|