Install's

Garry Driffill · #1 12-10-2008

Any one have an super tidy installs for the BJ4 Worlds car for me to have a gander at with a LRP/Nosram brushless system in. Ideally want the car to have no wires on show

Also looking for gearing on a 5.5 Brushless motor for general use all round.

Thanks

_sleigh_ · #2 12-10-2008

Might help

http://www.oople.com/rc/photos/euros...dayfour003.jpg

Richard Lowe · #3 13-10-2008

I'll PM you Garry with a picture of how my electrics are later tonight when I get back from work

Is the motor sintered or bonded?

Garry Driffill · #4 13-10-2008

Thanks Rich i remeber seeing youres at York actually the other night looked spot on. I think its bonded im not too sure i aint been paying too much attension to the Brushless scene to be totally honest as ive been racing brushed for a fair while and not really needed to dabble in Brushless.

Rich D · #5 13-10-2008

Hi Garry

Mine is a B44 but obviously almost identical anyway ........

Ive been told that fitting the speedo and motor on the same side affects the handling. However, using a setup from Rich Lowe and some lead on the opposite side it felt dialed at Worksop last meeting.

Pic shows NimH but with Lipo and a lead plate underneath, it was pretty well balanced on my 4 digital corner weight scales.

Garry Driffill · #6 13-10-2008

Looks really tidy that, Ive got the receiver infront of the motor at the moment im thinking of running the wires under the shaft solderd to upside down on the tabs so i have acess too the centre unit easily maybe..

Im using the Sanwa RX-431 Receiver so its not stopping a great deal of cool air to the motor, maybe if i move it further towards the front centre shaft i could squeeze a fan in too, Maybe an LRP/Nosram one.