Proline Bulldog on B44?

[MHeadling]

Just a quick question, does the Proline Bulldog fit the B44 chassis?

Or is it only B44.1??

[Timee80]

you would need to trim a few mm off the front sides of the chassis to make it fit.

[MHeadling]

Cheers for that, if its not too much chassis material to remove I may have a go, or buy the 44.1 chassis but I think this is about £50 ish so dremel time!

[Adam F]

I did mine to fit a punisher shell.

Had to trim the front, move the servo inboard a few mm and reposition the aerial mount.

[rob m]

i fitted a bulldog shell to mine no problems just got hacksaw and a file to trim front part of chassis, just cut it back as far as the under tray screw holes (about 2.5-3mm off). took me about 10mins to do didnt need to strip car down or pull electrics out.

[Col]

I fitted a bulldog.... Oh, no, wait, I didn't cos it's chuffin ugly!