|
|
#1
|
|||
|
|||
Mad monkey bodyshell and wing
hi guys,
i know this has probably been asked countless times before, but does anyone know where i can buy a clear or none-ansmann brand bodyshell and wing that would fit the mad monkey in the uk? like a proline shell etc? cheers! |
#2
|
|||
|
|||
i also want a clear shell for the monkey the b4 shell dont fit either as its not wide enough
|
#3
|
|||
|
|||
You could try the Phat Bodies Zen -
Its designed to fit the X-Factory X6 so there's a good chance it will fit the Mad Monkey. Available here - http://phatbodies.co.uk/ |
#4
|
||||
|
||||
Simon.......if that shell is narrow at the front then it won't fit the Mad Monkey as it's quiet a bit wider than the b4/x6 front end
__________________
oOple Trader Feedback: http://www.oople.com/forums/showthread.php?t=54309
|
#5
|
|||
|
|||
well i got annoyed at looking all over with no avail so iv bit the bullet and ordered 3 sheets of 0.75mm lexan (enough for 3 shells all going well) and i shall set about making my vacuum forming machine out of scrap bits.
i will let you all know how it goes success or not but if they go well i may be able to do the odd one or two. i will be changing the design tho adding a air vent that can be cut out allowing air flow directly onto the motor for added cooling so no heat sink needed |
#6
|
||||
|
||||
Hi all, I am waiting to order a body to make a mould from for the Mad Monkey as it seems a lot of people are after one as soon as it happens I will be posting it up, cheers Eric
__________________
|
#7
|
|||
|
|||
OK fair enough Lee I've not tried a Zen on a Mad monkey yet so can't say for sure. Would it be possible to trim the body up "over" the bulkhead ? I've done this before on wide chassis'ed cars with good results ...
|
#8
|
||||
|
||||
Simon, when I get 5 minutes ill try and measure the width front and mid, see how it measures up to ya shell ...... I personally would like a close fitting shell to keep as much cr@p out as poss
__________________
oOple Trader Feedback: http://www.oople.com/forums/showthread.php?t=54309
|
#9
|
|||
|
|||
Quote:
Here you go http://www.tcmodels.net/index.php?pa...mart&Itemid=71
__________________
I shop at www.tcmodels.net |
#10
|
||||
|
||||
Cool cheers for that I will be placing an order shortly once I have found a part number for a TR02C chassis, I am thinking of converting my saddle chassis to a stick chassis, seems to make more sense and it saves me having to borrow batterys of a friend everytime I go racing.
__________________
|
#11
|
|||
|
|||
Quote:
T02202 TR02C Chassis - Stick Pack Version http://www.tcmodels.net/index.php?pa...mart&Itemid=71
__________________
I shop at www.tcmodels.net |
#12
|
||||
|
||||
Beat you to it, just found it a couple of minutes ago, cheers for that, Cameo, looks like I will be placing an order today, as long as my body man can do the bodies fairly soon, I should have some available shortly, watch this space!!!
__________________
|
|
|