Lipo Experiences

[Lowie]

Originally Posted by mark christopher

how are you measuring this?
to check a lipo's capacity you need to discharge to 6 volts (3 volts per cell) on a discharger (not cut out in the car) then recharge to max capacity
what charger do you have?

how I measured this?
I just read it from the display from my charger after charging was complete.

I discharched my Lipo's till 6v and then charched them again with my Nosram Stealth Evolution-charger.
But I did this also with (through) the balancer atached.
I might try without it.
Also, maybe I could try to descharche and charge the two cells apart. I'll look into the manual of my charger how I could do this regarding the settings i should use.
Also, I guess I could try with a different charger?