Go Back   oOple.com Forums > Car Talk > X-Factory

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #20  
Old 14-05-2008
Paul_Sinclair's Avatar
Paul_Sinclair Paul_Sinclair is offline
Member
 
Join Date: Jul 2007
Location: USA
Posts: 203
Send a message via AIM to Paul_Sinclair
Default

Here's a quick pic of how I did the belt roller. The roller's shaft is actually a XX4 CVD front axle, with the round part cut off. The axle is the perfect diameter for a drive bearing, of course, and the little lip holds it on. The two "hat" spacers are just rear axle spacers (That go between the bearings and the drive pin). I just drilled the hole in the chassis by eye and adjusted it (file in or out as needed) as needed. The large "hat" spacers cover up the slightly-oblong hole, and clamp the whole thing tight on the chassis with a regular wheel nut on the end. Probably the hardest thing about doing this is you have to shave down one of the flanges on the drive pulley - just take your time with this and it'll come out fine.

__________________
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 09:58 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
oOple.com