|
|||||||||||||||
|
#2
|
||||
|
||||
|
hiya all here is the setup on my car from the morning practise
front 3 hole pistons drilled to 55 32.5 wt oil losi old grey springs 17.5mm ball cup no limiters inside but o-ring on outside tower middle wishbone middle ride height drive shafts just below level track 1mm with bw brace for strengh 10 degree hubs with castle removed to lower outer ballstud 10 degree wishbone mount longest camber link with 0mm washer on inside and no washers outside 10 mm space on steering link 1 degree of camber 0 toe in/out rear 3 hole 54 pistons 27.5 oil losi old red/brown springs ful lenth turnbukle ball cup with non threads showing no limiters outside or inside tower middle wishbone inside (hole replicated on rear of wishbone) rideheight driveshafts level wheel base, long (dry) short (wet) rear bulkhead altered with 2 extra holes drilled directly above the originals, (send me an email addy so i can send you pics) 1mm washer on rear mount 0 on front mount (you will have to dremel the top of the front of the wishbone so it doesnt rub against the purple alloy mount and bind up the suspension) shocks mounted in kit position the wishbone, ( if monted on the rear, this numbs the car down so you can add more steering to it and makes it better across the bumps) 3 degrees of toe in camberlink longest inside and middle on hub. 3mm washers on inner plate aditional info diffs both in low position overdrive pulley on front stiff chassis used solid 4wd high speed internal ratios used 5.5 on 22-23/83 40c 5300 lipos sp gt2.0 pro any questions feel free to ask
__________________
Nathan Ralls HPI, Custom Blitz, www.piraterc.com mr-o foams woop woop racing officialy keeping team toe out inline |
| Thread Tools | |
| Display Modes | |
|
|