Go Back   oOple.com Forums > Car Talk > X-Factory

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #3  
Old 14-08-2013
/tobys /tobys is offline
Mad Member
 
Join Date: Nov 2009
Location: Leicestershire
Posts: 1,370
Default

After finishing part B of the build (installing the front end), I would suggest test fitting your servo at this point. The benefit here is that if/when you dremel the nose plate (XF1002), the bits don't go all over the (almost) fully assembled car! You may find that you have to dremel a small amount from the upper most nose bridge piece to allow the server horn to reach full travel; again do this before assembling the rest of the car to avoid C/F dust getting all over your freshly assembled cube! Like Kevin, I had a prototype car and so there is a chance that the nose pieces have been altered for production to take this into account, so YMMV.

The manual is great and unlike other brands, you get useful advice at all key stages. I find the build of XFactory vehicles the least stressful of all the brands I have experienced and I put that down to Chazz's soothing words!
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 08:14 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
oOple.com