Go Back   oOple.com Forums > General > I Made This !

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #7  
Old 16-12-2014
Origineelreclamebord's Avatar
Origineelreclamebord Origineelreclamebord is offline
Mad Member
 
Join Date: Sep 2010
Location: Netherlands
Posts: 1,571
Default

Watch out with laser cutting and aluminium: Some grades (like 7075) have copper in them, which reflects part of the laser beam. This can (and in the copper fractions in 7075, likely will) lead to damage of the laser! Some other substances will also reduce the quality of the cut.

Instead, I would consider using water jet cutting: There's no heat build-up and as such less distortion and better retention of material properties near your cutting edges (especially for strain hardened or heat treated grades), you're not restricted in material composition (like you are with a laser), accuracy and edge finish are fine for a chassis plate and as far as my knowledge goes, for small batches and one-off work the costs are very similar.
__________________


3D Printing Upgrade Parts - FF210 Buggy

Last edited by Origineelreclamebord; 16-12-2014 at 09:00 AM.
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 01:27 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
oOple.com