|
#1
|
|||
|
|||
installing the electrics
Ok im at the stage when I turn a nice shiny new car into a messy load of wires. Ive installed the mamba max system into it without to many problems, but I plan to have my novak velocity system in there as a permanent feature.
Any installation advice before a start chopping up and soldering? Im guessing the reciever is going to have to be mounted on the moterside rather than what the instructions suggest. Is there any problems with body clearance, havent cut the body yet? and where to put that bad boy power cap? cheers dan |
#2
|
||||
|
||||
Hi there, I beleive there is a Bj4we thread about the same sort of thing. And by the look of both of the cars they seem pretty similar so you could just try and install it like one of them.
Here is the link :http://www.oople.com/forums/showthread.php?t=3822
__________________
B4 5.5 L4 19T RC18t Mamba 9200Kv
|
#3
|
|||
|
|||
thank you, i shall check it out now
ta |
#4
|
||||
|
||||
I've mounted my spektrum receiver on top of the steering servo with double sided tape for now until I can afford the spektrum micro to replace it with. I put double sided tape on the power cap and stuck it against my Nosram BL esc so it's stuck to the esc at the side and the chassis at the bottom.
Probably not the best way of doing things but there was room for the receiver where I've put it and being 2.4 I havn't had any interference problems. |
#5
|
|||
|
|||
ive got spektrum too so maybe i will do that. Although may get the micro reciever to.
cheers |
|
|