|
#1
|
|||
|
|||
New build 410R questions
I'm half way through building a 410R and I can only find setup sheets for the 410, which raises two questions.
1. The R towers have four front and five rear holes. How do these holes relate to the three holes in the 410 towers? 2. The steering plate shows three holes F C and B, whereas the 410R plate only has two holes - again how do these relate?
__________________
Tony Mulligan DESC410R, DEX410, DEX210, Cream Extreme (the dog's b******s) www.srcc.co.uk |
#2
|
||||
|
||||
Ignore the outside hole on the towers . Few people cut them off to limit breakages. For the steering rack ive always ran mine in the front hole. It's the same place that most of the 410 setups use
|
#3
|
|||
|
|||
OK thanks.
Just to be clear the 410R rear tower has five holes - do I ignore the two outside holes on this one?
__________________
Tony Mulligan DESC410R, DEX410, DEX210, Cream Extreme (the dog's b******s) www.srcc.co.uk |
#4
|
||||
|
||||
|
#5
|
|||
|
|||
The extra holes are for the DESC410R I believe, as Diesel said just ignore them. Cutting them off is useful too.
|
#6
|
|||
|
|||
OK many thanks - all is clear now.
__________________
Tony Mulligan DESC410R, DEX410, DEX210, Cream Extreme (the dog's b******s) www.srcc.co.uk |
|
|