X11 setting for very loose track...

[Naushad]

Hi

Im glad you sorted this out!

I have two preds both quite new! One just has been rebuilt!

Any tips you can give about electrics to install and indoor setup?

Do you use stick or saddle lipo?

Thanks

[restimax]

i use lipo stick, the esc is a xerun 120 v.2.1 blu version, fitted on chassis behind the shocks, the servo position has been set back of 12 mm to the motor (one 6.5, but i think is better one 7.5 on slippery track)
nothing additional weights.
what's the surface of your indoor track?

[Naushad]

Ok...intend to run on carpet or AstroTurf.

Could you post a picture of your internal setup?

Originally Posted by restimax

i use lipo stick, the esc is a xerun 120 v.2.1 blu version, fitted on chassis behind the shocks, the servo position has been set back of 12 mm to the motor (one 6.5, but i think is better one 7.5 on slippery track)
nothing additional weights.
what's the surface of your indoor track?

[restimax]

Uploaded with ImageShack.us

[Naushad]

Thanks restimax

You have used saddle in that picture. But i guess you can use stick aswell.

Seems like it is tight to fit everything in but you have
Managed it!

Does it get very warm?

I'll post my setup soon. I might use:

Saddle lipo
Tekin rs or rs pro
8 t motor
Low profile savox servo

Thanks again

[MHeadling]

Have a read on my build thread, also some good ideas on layout.

http://www.oople.com/forums/showthread.php?t=88430

[t8rtot]

Anyone using shorties in their preds? Wandering if putting it towards the rear moving the esc or rx over would befit weight distribution.

[yaji]

[Front]
Big bore shock
piston　57/2hole　（no-valve）
oil　AS30
spring　6.5T black
No-limiter

caster　right back(max caster)
canber　-1.5deg
toe out 1.0deg
anti roll bar no
push lod length　61ｍｍ（hole to hole）
ride height　19ｍｍ（bone level）

[Rear]
Big bore shock
piston　57/2hole
oil　AS35
Spring　6.0T Black（P-spring non）
No-limiter
Caster　stock
canber　-2.0deg
toe lod length　48ｍｍ（hole to hole）
anti roll bar　1.1ｍｍ(Kyosho ZX-5)　back pibot
ride height　21ｍｍ　（lower arm level）
up-right hole　lower hole
apper arm　lower
shock position　middle hole

[Drive train]
supre gear　72T
Pinion gear　20T
Front diff　Full time 4WD
ESC　keyenth tachion
motor　LRP　X11　7.5T
battery　hyperion SWIFT　4200
tire　F/Pro-line hole shot M3　R/Pro-line hole shot 2.0 M3
innner　F/Pro-line stock　R/Pro-line stock （2.0）

[Other]
Rear wing　Durango　full garney
Shock O-ring　Kyosho X-ring Orange
Lipo-chassis（hard）
NEW-orange steer arm

Good luck mate

[restimax]

thanks mate!
thisi is very similar to my last setting.

because you use a kyosho orings?