|
#1
|
|||
|
|||
Tm2 v1 steering lock...? Can't achieve full throw
Is there any upgrade/mod needed to achieve full throw? I'm struggling to get full throw especially tinting right. I've got full dual rates and the steering is fully locked out but will not go any further
Any help much appreciated Gav
__________________
TLR ABSIMA Horizon Hobbies G Paint Answer RC |
#2
|
||||
|
||||
If you have the updated nose plates with the strengthening post check this as the servo saver and idler arms hit the post before full lock, just file the post down to add some clearance. Also the inner ball joints on the front track rods touch the saver and idler arms, again just remove a little material from the arms on the inner edge of the kink.
|
#3
|
|||
|
|||
Nose plate? Do you mean the front chassis plate? And idler arm? Looked at the manual and can't see these parts?
Gav
__________________
TLR ABSIMA Horizon Hobbies G Paint Answer RC |
#4
|
||||
|
||||
The other option is totry and find the origional top and bottom nose plates with no centre screw, problem should then be cured, had the same problem with my tm2
__________________
Tm2, LRP, Sanwa, SMD, Schumacher KC, L1, PBM Racing |
#5
|
|||
|
|||
I put the ball stud in the front of the ackerman arm so the ball ends to not bind. Use thinner washers under the screw heads which go through the ackerman bar. Remove the small plastic lumps on the steering arms which the ackerman is mounted to this stops the screw heads hitting the lower plate. Remove some plastic from the front C-Hubs so they have a 45 degree chamfer so that the steering knuckles can move further. Remove some of the plastic in the upper and lower front end parts so as to allow the steering arms to have more travel.
__________________
Schumacher KC, KD, CAT XLS, CAT L1 | Team C TM2 V2, TM4, TC02 | JQ The Car | Mugen MBX6 | Losi 8T,8BE 1.5 | Durango DEX-410V4 | FTX Blaze | XRAY M18T | Kyosho STR,Surf Dude,Nexus 30 | Nimrif Makara | MFA Spear | She Devil | T-Rex 450SEV2,250SE | Ark X-400 | Protech Butterfly,Zoom 400 | Ikarus Piccolo | VW T4 | Smart 450 | KC-250 | BoltRC Kraken 5" | Emax Nighthawk 250 | Gravity 250 | S550 | Prusa i3 | TronXY X5A | Must stop collecting stuff! |
#6
|
|||
|
|||
Cheers for all your input guys I'll have a play with the dremel and sort it out
__________________
TLR ABSIMA Horizon Hobbies G Paint Answer RC |
#7
|
|||
|
|||
All sorted now lads cheers, seems a bit of a crap design that you have to dremel several areas of this car.... But I guess it performs bloody well!
__________________
TLR ABSIMA Horizon Hobbies G Paint Answer RC |
|
|