|
#1
|
||||
|
||||
Problem with alloy rear hub
Anyone that has the blue version (not the old one) of the alloy rear hub noticed some play/slack in the left hub? I have 2 sets of them and both have the same problem.
When you put the wheel on and tighten it down, there is still some play toward the outside, about 1 a 2 mm... Wondering if the newest version (black) still has the same problem and if there is a quickfix?
__________________
- Bmax -
|
#2
|
||||
|
||||
I don't have that particular problem. But try to add a shim?
__________________
Numquam cedunt victores, numquam ignavi vincunt. |
#3
|
||||
|
||||
I have some play in de right hub, but its only .5 mm. Havent tried shimming it.
__________________
Schumacher KC - Tekno EB48.3
|
#4
|
||||
|
||||
Quote:
__________________
Top Notch |
#5
|
||||
|
||||
Thanks for the reply's! I checked the bearings tonight but they are okay. It looks like the crushtube is just a bit to wide... Will sand it tomorrow!
__________________
- Bmax -
|
#6
|
|||
|
|||
I use the blue Alu hubs and yes my left, the bearing comes out a bit. The right bearing is in tightly. I remember when I first put in the bearings, not sure if both but one at least was a pain to put in, had to apply some grease and even then it was a tight fit.
I just gave my bmax4 a run in the street and it tracks straight at half throttle, at full starts to pull ever so slightly but my street has camber. |
|
|