|
#1
|
|||
|
|||
Dark Impacr/brushless fitment.
Just went to fit my Vector motor into the DI and have come across a problem. The solder tabs that stick out the side are restricting the positioning of the motor against the motor plate. I have tried every position possible, but with no luck. The only thing I can think of is mounting a spacer between the motor and the moto plate, this does then allow the solder tabs to clear any restriction.
My concern with this method is that the motor plate wont be working as a heatsing dicipating the heat from the motor? |
#2
|
||||
|
||||
you could always dremmel some material out of the plastic brace.
__________________
dragon paints : team tekin : fusion hobbies :SCHUMACHER RACING : Nuclear R/C for all my sticky and slippery stuff - if it needs gluing or lubing, Nuclear RC is the man! |
#3
|
|||
|
|||
Just had a mess about and depending on gearing I can just get the motor fitted. Theres minimal(2mm) clearance between the rear housing and one of the solder tabs. SHould be OK. Will try and get pics at some point.
|
#4
|
||||
|
||||
A guy I know races a DI like myself. He did have to do some adjusting when he installed his Novak 4.5 brushless system... BTW-his 4wd is the fastest at the track!!!
__________________
TRF501X - 201 |
|
|