|
#1
|
|||
|
|||
![]()
best method?
Dont fancy drilling, would double sided/or velcro be strong enough? |
#2
|
|||
|
|||
![]() Quote:
Have you tried to contact him? Personally I woundn't use velcro. So some decent servo tape maybe the way forward. |
#3
|
|||
|
|||
![]()
Best way is to Place in Chassis and drill through with small drill bit.Then open out with clerance drill.Counter sink from under chassis.Hope this helps.
__________________
ASH DOES THE DRIVING ... IM THE MECHANIC ![]() Team Schumacher |
#4
|
|||
|
|||
![]() Quote:
PM Tony or wait for him to respond to the thread before getting your drill out. |
#5
|
||||
|
||||
![]()
I think andrew means spot drill the chassis through the existing holes in corner weights etc to mouny in chassis
__________________
Dragon Hydrographics TEAM DAD RECOMMENDS- TRACKSIDE SPARES- NUCLEAR-RC |
#6
|
|||
|
|||
![]() Quote:
![]() |
#7
|
|||
|
|||
![]()
sorry, its for the x6.
and its for the whole drill set, servo, speedo,lipo and rear weights |
#8
|
||||
|
||||
![]()
Agreed but the chassis are awful to countersink you'll go steady and think you've got them nice and concentric then on inspection find the darn things wandered, the lipo weight's just sit in loose
|
![]() |
|
|