|
#1
|
|||
|
|||
Mad Monkey/Lupuz: what shocks and other bits?
It's the weekend, I'm bored. If I buy a Mad Monkey kit to build I already know the kit shocks are not really ideal for racing (or as I prefer to call it, driving round sedately getting in the way ) so will either Losi XXX-CR, Associated B4, or Tamiya TRF shocks fit as I've already got some of these in my spares pile so don't need to spend anything extra.
What else is crucial for a Monkey kit to make it race ready other than a POM idler gear, a bearing set and the shocks and some turnbuckles (again already got plenty of them)? Ta. |
#2
|
||||
|
||||
Hi.
The xxxcr shocks fit but you will need the ball mounts also. Pink rear and blue/black front springs work well. The monkey comes with bushings and obvious upgrade is bearings so that's the first job. As for other bits I think you have covered most areas but to be honest the diff balls are a bit soft and graunch after a very short time. Go for some of buds ceramic bearings as they are a vast improvement. Neil
__________________
Caster Racing Team Driver Team C My Feedback..http://www.oople.com/forums/showthread.php?t=85397 |
#3
|
|||
|
|||
Ah, that's good. Anybody know if the Team C upgrade driveshafts fit so I can use some of my 24,000 sets of B4 rear wheels?
|
#4
|
|||
|
|||
As for the pin drive, speak to Dave Dodd, he runs pin drive wheels on his x2c.
__________________
"I`m sorry Mr Race Controller, i misjudged the turn and ended up going full chat straight into him!!!" Life`s Boring unless your sideways. |
#5
|
||||
|
||||
Yes the driveshafts fit,essentially the same as the x2c same geometry etc just softer plastic. All the hop ups fit.
__________________
Caster Racing Team Driver Team C My Feedback..http://www.oople.com/forums/showthread.php?t=85397 |
|
|