|
#1
|
|||
|
|||
Fitting a Savox 1251 in a 210
Hi
Just got a low profile 1251 for my 210, but I can't get it to fit due to where the wires come out of the casing. Am I doing something wrong or do I need a different servo? Thanks |
#2
|
|||
|
|||
More jiggling needed, all servos are a bit tight due to the shape of the chassis side rails.
If you are worried about bending the servo wire, try relieving the rail there, 2 minutes with a dremel should do it...... |
#3
|
|||
|
|||
You should use a servo saver with the 1251 servo or you will need to replace gears often..
|
#4
|
|||
|
|||
Thanks for the advice guys.
|
#5
|
|||
|
|||
Hope you have no Tekin ESC, is not working with Savox
|
#6
|
||||
|
||||
You might also need a glichbuster capacitor as well because savox servos can draw to much current from your ESC
|
|
|