|
#1
|
||||
|
||||
Using liquid mask over Vinyl masks
I have been given a body to paint for a friend and I want to make a really good job of it as the shell was not cheap.....
I have always just used liquid mask, the design i have in my head would mean a lot of cutting, so if i put small pieces if vinyl mask on then liquid mask and cut round where i need to. As i peel the liquid mask off will it peel off the vinyl? I'll be using RCS liquid mask and RCS vinyl. Ta in advance
__________________
TLR 22-4 2.0 TLR 22 4.0 I have some feedback from trades done a while ago. Trader Feedback |
#2
|
|||
|
|||
I've done this a couple of times, it's fine. For lettering etc, I completely cover the shell in LM once the graphics are down, then cut as required. I spray on my LM through a 0.5. Needle, watered down to the consistency of milk. Gives a great smooth finish. I flash it off with a hair dryer between coats.
|
#3
|
||||
|
||||
I've never had any problems combining vinyl and LM, it's the way to go !
|
|
|