|
#1
|
|||
|
|||
esc / motor problem
Hi all, hoping someone may be able to share some advice and help
my 4wd buggy has a HW2.1 ESC flashed with the upgraded software Ive had problems with motor/power shutting down/car dying after full throttle and then braking to try and isolate issues I have gone through the ESC and turned off voltage protection, thermal protection etc, but still does it motor is 6.5 orca TX I have turned off boost and turbo and put punch to minimum end of straight I usually brake before the sweeper just to get car slowed a bit and into the astro then turn in and punch it again, but with the 4wd I cant do it as every other lap or so it will just die and then maybe 1 to 1.5 seconds later it will work again been having a read online and now Im wondering about either the power caps on the ESC? or putting a capacitor across the receiver pins? I read about savox servos causing brown out and voltage going too low for the receiver I dont have savox, I run oirion or corrally, but as its 4wd with 6.5, could this be a similar issue? have a regional meeting in 2 weeks and would like to sort before then
__________________
AE all the way RC10B6.1d Maclan powered RC10T6.1 Maclan powered RC10B74 Maclan powered #rcoctane #teamrcoctane |
#2
|
||||
|
||||
Have you tried factory resetting the speedo?
Sounds like it could be power caps, but what about trying a different motor to see if the problem persists?
__________________
:: AE B5MCE - SP 7.5 v3.0 Brushless Motor - Reedy Shorty Lipo - Savox Servo - Spektrum Rx :: :: Paint By Turnip Paint :: |
#3
|
|||
|
|||
Do you have reverse on? My HW v2.1 would stall for a brief period when I double braked into a corner, I assume it was activating the reverse function, but then would take time to activate forward again. I just turned off reverse all together and it sorted it.
I'm currently using a HW v2.1 with a Savox servo without any issues. |
#4
|
|||
|
|||
If your up at Mendip over the weekend, I have a power cap you can try out if you want.
|
|
|