|
#1
|
|||
|
|||
Transponder Port on Receiver
Hi All,
Can someone remind me which port on the receiver the transponder is normally plugged into? Thanks! |
#2
|
|||
|
|||
A spare one
Ch3 usually
__________________
AE all the way RC10B6.1d Maclan powered RC10T6.1 Maclan powered RC10B74 Maclan powered #rcoctane #teamrcoctane |
#3
|
|||
|
|||
Thanks Tony!
|
#4
|
||||
|
||||
Any providing its not steering and throttle channel, all the plus and minus pins are on the same track in the circuit board. Only signal wire varies. I all ways use the B (battery) port.
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD |
#5
|
||||
|
||||
If using the Core Code system ch3 can be switched off on the TX, seen that a lot
|
#6
|
||||
|
||||
The transponders are normally plugged into the battery port on the receiver.
__________________
|
#7
|
||||
|
||||
Correct as can ko, but it does not disable the positive and negative which powers the pt, they are as I put above all on the same tracks on the circuit board
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD Last edited by mark christopher; 25-10-2017 at 09:54 PM. |
#8
|
|||
|
|||
Thanks all!
|
|
|