|
#1
|
||||
|
||||
stupid question time
. i have had some one spray a shell for me for a vega 4.1. i brought the car with out a shell. the one i have had done i think he said its for a c4.1 so not a purfect fit
how ever after cutting out and get it seating properly(ish) what is the best way of keeping it on. as there is no body clip points. i was looking at useing the ones out of a pred x11 and tapping the chassis and cliping threw the side or is velcro an option just wondered what other people have done
__________________
pro95 (s/n111554), dtmi, rally, xk98 (in the post), XRS (s/n6120), X10, X11-08, X11 lipo B4.1 vega |
#2
|
||||
|
||||
Strip of velcro up both sides of chassis. Simple and effective
|
#3
|
||||
|
||||
Not tried it myself but seen it on the C4.1, use the B4 bolt with the hole in it for the body clip and screw this into the front bulkhead and pop a hole in the shell.
Use velcro along the sides too. |
#4
|
||||
|
||||
My mistake . its a gen 2 shell. yep i dont know what i brought
__________________
pro95 (s/n111554), dtmi, rally, xk98 (in the post), XRS (s/n6120), X10, X11-08, X11 lipo B4.1 vega |
#5
|
|||
|
|||
The shell is a standard kit Vega Gen 2 shell.
You need to cut quite a bit from the front to get it to fit on a Gen1 chassis. The do fit fine though, My Gen1 vega is running the Gen2 shell. |
#6
|
||||
|
||||
Matt can you up load sime pic for me please
ben
__________________
pro95 (s/n111554), dtmi, rally, xk98 (in the post), XRS (s/n6120), X10, X11-08, X11 lipo B4.1 vega |
|
|