|
#1
|
|||
|
|||
PT Connection
Any of you techies able to help? I have a PT I want to install in my SCT. It has a Spektrum SR300 receiver installed with a Cap in the 'aux' socket (Savox servo!) obviously the steering and esc in the others. Will the PT work in the 'bind' socket or can you get a 'Y' branch connector or something?
__________________
SCTE, XB4, TEKIN Loads of others in bits amongst the broken planes and helicopters!!! |
#2
|
|||
|
|||
It's not going to work in the bind socket, but getting a Y-harness will work fine for your purposes (either in your aux socket, or I even used them in the past on 2-ch rx's plugged into the steering socket).
|
#3
|
|||
|
|||
Thanks Robby, I will try that.
__________________
SCTE, XB4, TEKIN Loads of others in bits amongst the broken planes and helicopters!!! |
#4
|
||||
|
||||
Give it a try plugging it into the bind socket, you may be pleasantly surprised.
If I remember correctly, most receivers have common lines for the + and - and that should extend down to the bind socket. At the very least you won't do any damage as the bind plug connects the signal pin to the - pin.
__________________
Dragon Paints |
#5
|
|||
|
|||
i4n
You spot on mate, works great in the bind port, thanks a lot.
__________________
SCTE, XB4, TEKIN Loads of others in bits amongst the broken planes and helicopters!!! |
|
|