|
#1
|
|||
|
|||
Bmax4iii lightweight...which rear prop shaft?
Hi all
Getting confused with parts/numbers. Bmax4iii with shorty chassis, it's currently got a gun metal green rear prop shaft, (slipper to rear diff) which I believe is the light weight version? It's destroyed the CV joint onto rear diff input shaft (also alloy version), so I'm looking to replace the whole rear prop shaft including input shaft. Which part do I need? I can't locate a number for the alloy version...to be honest I'd happily put a standard rear prop in it but I'm unsure which one I need? Did the shorter chassis move the slipper and therefore have a different length rear shaft? Or did they extend he slipper output to accommodate the extra length? And one seems to be listed as a 'c-clip' rear shaft?! Any help/advice appreciated. Andrew |
#2
|
||||
|
||||
Quote:
I may have the short and long shafts mixed up here though, as it all depends which way you have the motor pod rotated, as to which one at the rear you have broken. The alloy lightweight ones were an option. B4-CB68A - 68mm B4-CB76A - 76mm Kit parts: BM-010CRC - Front - Short B4-010CR - Rear - Long The gear shaft end - B4-303 and B4-303A. The CVD pin and ring - BM-010TPC So if you are running the shorty pack, you may have the short shaft to rear, so 68mm. MB models still carry all the bits you need.
__________________
-------------------------------------------------------------------------------------------------------------------
Team Yokomo - YZ-2CAL3 | YZ-2DTM3 | YZ-4SF2 | YZ-2T | YZ-2DTM Worlds | YZ-2DTM x2 | YRX-12 x2 ------------------------------------------------------------------------------------------------------------------- 10electric | Batley Buggy Club | YORCC | RHR | MB Models --------------------------------------------------------------------------------------------------------------- |
#3
|
|||
|
|||
Neal thanks loads for such a comprehensive reply, really appreciate it.
Very strange the way it's chewed up the diff input...I might try just replacing with a steel input shaft and see how that goes. Thanks again! |
#4
|
|||
|
|||
parts
Hi, I have a bmax4-iii car lying around and some extra shaft parts if interested? thanks,Phil
|
#5
|
|||
|
|||
Thanks Phil, post was from July, now sorted. : )
|
|
|