|
||
|
 |
|
||||||||||||||||||
|
#1
21-02-2010
|
||||
|
||||
What 2.4 Radio Gear?
Hi guys
going to go 2.4 (at last) & fancying the latest Ko Propo Esptrit lll. Anyone out there had any bad experience's with it or recommend anything else? I'm using the Futaba 3VC at the mo (40mhz) & fancy a change. Any addvice will be greatly recieved. Cheers 
|
|
#2
21-02-2010
|
||||
|
||||
|
Have been using the Ko Propo Esptrit lll for the last 12 months. Very good and touch wood very reliable.
Done 2 mods to it. Moved module areal to where the metal extendable one goes and put a 11.1v Lipo battery in.
__________________
Associated SC10. Associated RC8. Atomic Carbon S4. Paint by Wezzer. 
|
|
#3
21-02-2010
|
||||
|
||||
|
If you have the 3VC, you could simply acquire a module system to go 2.4Ghz, which is best if you're fond of the handset.
Spektrum's module kit is the most obvious solution (cheaper than Futaba's own, especially RXs), though there are some others (I'm using the Assan futaba module in a Hitec CRX, which has small and cheap RX modules, works fine, apart from not allowing saving of settings when the module is plugged in...I just pop it out to save). A word of caution - the KO 2.4Ghz receivers are fearsomely expensive.
__________________
 Photos: Oople Invernational 2010 - Sodden Sunday Muchmore N. Irish GP 2010 (Touring cars) BADMCC 1/8th Nitro buggies Current cars: X6^2 | JC BJ4WE | TM E4 & E4JS | HPI E-Firestorm | Losi Crawler | + many F1s, super crawlers, scalers, drifters in the works...
|
|
#4
21-02-2010
|
||||
|
||||
|
Ive got a snwa exzes plus, its very good and recievers seem cheap aswell which is a bonus.
I have had a 3vcs 2.4 aswell and the reciever lasted 10 mins then over heated so they sent another oe and same again so i swapped. and they did have the yellow dot on that im told means they have a higher heat grade?? Chris
__________________
MY FEEDBACK - http://oople.com/forums/showthread.p...hris+Griffiths XRAY Tecnopower AKA AMMO Fuel HUDY RC Disco
|
 |
|
|
Linear Mode
