|
|||||||||||||||
|
#1
|
||||
|
||||
|
Hi chaps, does any one know where to get roll pins for the wheel drives on a 501/511??
I have tried Cat ones but they are too small, so to are AE ones. Would be a good part for it as the STD kit silver ones drop out when you take a wheel off. |
|
#2
|
||||
|
||||
|
Quote:
Oh, and to stop them falling out, I use loctite on the pin! |
|
#3
|
||||
|
||||
|
I think the UJ pins work (in the rebuild kit part 53500), Northy is selling some!!
|
|
#4
|
||||
|
||||
|
DELETED
Last edited by jhammond; 08-06-2015 at 09:18 PM. |
|
#5
|
||||
|
||||
|
Quote:
Andy
__________________
|
|
#6
|
|||
|
|||
|
Quote:
thanks Migs |
|
#7
|
||||
|
||||
|
Was going to say, dip it in the AW grease before putting the pin through the axle, holds it in place good and proper...
__________________
dragon paints : team tekin : fusion hobbies :SCHUMACHER RACING : Nuclear R/C for all my sticky and slippery stuff - if it needs gluing or lubing, Nuclear RC is the man! |
|
#8
|
|||
|
|||
|
Actually you can just use shims. Be careful, just enough to hold the pin, not so much that it binds.
|
|
#9
|
||||
|
||||
|
Quote:
![]() (I use shims aswell, helps eliminant the wheel rocking around, seems to run alot truer)Andy
__________________
|
|
#10
|
||||
|
||||
|
http://cgi.ebay.co.uk/ws/eBayISAPI.d...#ht_2306wt_941
Seem to be sold out, but I'm sure something similar could be found. |
|
#11
|
||||
|
||||
|
Actually...
Just found some. See: http://cgi.ebay.co.uk/GS-Racing-6020...#ht_523wt_1167 £2.00 with free postage. |
|
#12
|
|||
|
|||
|
thanks Julius
|
![]() |
|
|