|
||
|
 |
|
||||||||||||||||||
|
#1
06-09-2012
|
||||
|
||||
smaller spur on 410
Possibly a daft question but is there a way to fit a smaller spur to the 410 to buy a little extra clearance from speedo/radio, but still be able to mesh a smallish pinion to it. The reason I ask is I have tried it with an 81 tooth and the pinion won't mesh, unless I go to about 24 but then I'll be overgeared.
Cheers
__________________
|
|
#2
06-09-2012
|
||||
|
||||
|
to gain room surely you want a bigger spur to move the motor,
Unless you mean from the spur itself
|
|
#3
06-09-2012
|
||||
|
||||
|
No mate I mean smaller spur as I have very tight clearance between my esc and the spur (esc is large hobbywing one), with the receiver positioned tight in front of the speedo. So the wiring/terminals are about half a mm from the spur. I also like everything neat, but that's another issue. If I can't do this I will have to look at moving receiver under the propshaft.
__________________
|
 |
|
|
Team Durango
Linear Mode
