|
#1
|
|||
|
|||
Futaba 3vc dual rate problem
Hi,
I have a Futaba 3vc which i am having a problems with and I was hopeing somebody might be able to help me out Basically When i adjust the dual rate on my steering settings, the steering moves as if im adjust the steering trim? if anyone could help with this or advise what I should do would be great cheers Last edited by sam-1210; 06-08-2015 at 08:18 AM. |
#2
|
||||
|
||||
All the buttons are programmable, sounds to me like the settings have been changed.
Scroll through the menu's and you can change it back
__________________
Schumacher Speed Passion Futaba Support from: My Back Pocket Driver - 'Derek' Feedback Link : http://www.oople.com/forums/showthread.php?t=48311 |
#3
|
|||
|
|||
This is a quite common issue on all the Futaba handset that use the 3vc gimbal assembly, so:
- the FF3 (T3UCP) - the 3VC (T3VC) - the 3VCs (T3VCs) - not all, but the newer 3GR - the 4GRS This behavior happens when a meccanical offset occurs between the plastic stick part that holds the potentiometer and the potentiometer shaft. The 3VCs and the 4GRS have an special menu that performs a new transmitter calibration in order to fix this issue. For all other transmitter listed the best advice I can give you is to send your radio to Ripmax for a factory recalibration. Bye Ema Last edited by Ema; 06-08-2015 at 12:58 PM. Reason: Typo |
|
|