|
#1
|
||||
|
||||
xcelorin 7.5T smoke
Decided to just check things over before tomorrow and now when I run the motor I get a burning smell and smoke. About 30 seconds running.. What the hell is gone wrong now
Checked the wires and all looks ok. It gets very hot quickly, motor is just getting hotter and hotter Looks like I won't be racing for a couple of weeks now Spektrum / KO Helios LRP SPhere TC LIPOS and NIMHs |
#2
|
||||
|
||||
Sounds like one of the sets of windings is burning out, or is shorting slightly. Take/Send it back IMO.
Otherwise check that the wires match up correctly from the speedo to the tabs. If it sounds quite noisy, then you may have some of the wires matched up incorrectly, which means that the rotor is not turning properly (if you see what I mean). It would also explain the motor getting hot! Check this first!
__________________
:: AE B5MCE - SP 7.5 v3.0 Brushless Motor - Reedy Shorty Lipo - Savox Servo - Spektrum Rx :: :: Paint By Turnip Paint :: |
#3
|
||||
|
||||
Quote:
Poo, just my luck and bought it 2nd hand from someone off here... Who handles Losi warranty.. Yup it's noisy, that's what drew my attendtion to it. |
#4
|
||||
|
||||
Could be the rotor going/magnet. Would also explain it getting hot. Have you possibly overgeared it, or not run it yet?
Horizon deal with Losi electrics. PM Southwell on here for more info. HTH Mark
__________________
:: AE B5MCE - SP 7.5 v3.0 Brushless Motor - Reedy Shorty Lipo - Savox Servo - Spektrum Rx :: :: Paint By Turnip Paint :: |
#5
|
||||
|
||||
Quote:
It's smoking with no wheels attached etc. and then I removed the pinion OK I'll PM him |
#6
|
||||
|
||||
Sounds faulty to me then....
Must be shorting out internally somewhere on one of the windings.
__________________
:: AE B5MCE - SP 7.5 v3.0 Brushless Motor - Reedy Shorty Lipo - Savox Servo - Spektrum Rx :: :: Paint By Turnip Paint :: |
#7
|
||||
|
||||
So how come it runs fine and then packs in on my desk?? Did you say other people have had this issues?
|
#8
|
||||
|
||||
Not heard of other people with this issue! I have two of them, which are fine!
You must just be one of the unlucky ones.. The previous owner may have given it some abuse, which you didn't know about... Just trying to help dude! Regards, Mark
__________________
:: AE B5MCE - SP 7.5 v3.0 Brushless Motor - Reedy Shorty Lipo - Savox Servo - Spektrum Rx :: :: Paint By Turnip Paint :: |
#9
|
||||
|
||||
Quote:
For me I've just going to by new stuff now. |
#10
|
||||
|
||||
Quote:
For me I've just going to by new stuff now. I had it running fine, nice and cool as I checked it all over when it first ran. Then pop tonight Just removing it and starting to pack it up for horizon hobby |
#11
|
||||
|
||||
defo sounds like one of the coils have gone hence the smoke/burning epoxy burning probably shite joint on coil plate
__________________
who knows who cares |
#12
|
||||
|
||||
Quote:
Found the 7.5T very quick too, so may buy a 9.5 ish too |
#13
|
||||
|
||||
doesnt matter what brand its more bad luck nothing wrong with losi or any other brand just mass produced now and again you get a monday morning motor
__________________
who knows who cares |
#14
|
||||
|
||||
Quote:
I never have good luck so that'll be about right.. Fingers crossed for a speedy resolution Gives me time to fit my new Losi shocks to the B4 |
#15
|
||||
|
||||
well I wonder if it's been caused bu an ESC issue as it ran fine for the person who is checking it for me...
time to buy a Tekin / test with another brushless tomorrow. a trip to demon might be in order.. |
#16
|
|||
|
|||
My Losi Xcelorin esc caught fire tonight will contact Horizon after the bank holiday.
|
|
|