jorn neumann

[fastfilli]

Front:
0 degree toe in
30 degree caster total = 5 degree hub / 25 degree chassis kick up
Hub camber link = outer most hole
shock mount camber link = inner most hole
spacers under shock mount link = 2mm
1.5 degree camber

Rear:
3 degree toe in
1.5 degree anti squat
Hub camber link = 3rd hole in. left 00X0 right 0X00
spacer under shock mount link = 4mm
1.5 degree camber
hub carrier on medium wheel base

[fastfilli]

Oh P.S

Yes that looks the correct Hotbodies part.
They are available in a pack of three if I remember soft, medium & hard.
I am sure most modern touring car rear roll bars will fit as they are all very similar. The bottom rose joint that fits to the suspension arm must be a durango item, I found this item spare ,left over from initial build they are the joints used connecting the servo the steering rack.

[drop4205]

On jorn's setup with nanobytes, does he narrow the front rein or leave it full width. Doesnt say on the sheet but the pics look like it. Setup im looking at is on Petitrc.com and his Dortmund setup on 4-22-2012

[Chris-S]

Originally Posted by drop4205

On jorn's setup with nanobytes, does he narrow the front rein or leave it full width. Doesnt say on the sheet but the pics look like it. Setup im looking at is on Petitrc.com and his Dortmund setup on 4-22-2012

Full width rim with the 2wd nanobytes. I used a schumacher hard insert, as the sidewalls are no where near as stiff as the schumachers.

[chris_dono]

Kit setup works just fine with 450/350 oils front and rear at Eden Park